Enables use of the switch's USB port.
| usb | Specifies USB port on switch. |
Enabled by default.
This command requires a reboot to take effect. This setting persists after reboots. To remove it, use the command disable switch usb or use the command unconfigure switch {all | erase [all | nvram]} with the all option.
Stack support is not available. You need to run this command individually on each node in a stack.
The following example enables use of the USB port:
enable switch usb This setting will take effect at the next system reboot.
This command was first available in ExtremeXOS 22.3.
This command is available on all Universal switches supported in this document.